Bests & Worsts Reviews from Amazon

I bought this because it came with three punch sizes. My watch band has pins smaller than one mm. The others come with a number of punches, but don't say if they're different sizes or not. The descriptions just say they're spare punches. I didn't get the one that worked like a press. I think using the small hammer and tapping gently gives more control than one of the press type tools. I like this because there's nothing to get out of alignment or jam. The only way to improve this would be to provide punch storage in the base. It took me just a few minutes to remove two links from my watch band, one from each side of the clasp. The punches are 7/16" long, long enough to push the pins over half way out. The small hammer has a plastic face for driving the pins back in. I also found a magnifying visor very helpful. **** Addition to review. I've now used this to shorten three watch bands. The last was a women's watch that had pins that were very tight. I just kept tapping and the pins finally came out. Don't tap too hard, let the hammer do the work. The watch band holder has slots of different widths to handle different watch bands. **** I just measured the pins I received with the SE JT6218 Watch Band Link Remover. They measured as follows: 0.031 inch = 0.79 mm 0.035 inch = 0.89 mm 0.038 inch = 0.965 mm I used a Starrett 120A-6 dial caliper like this one, Starrett Dial Caliper, American Made, Inch