Bests & Worsts Reviews from Amazon

This is by far the best Pi3 case you can get right now. Nicely done *** To make your own Red Led Power light *** --- This Kit linked below has all the components needed to add Red Led Light --- CanaKit Raspberry Pi GPIO Breakout Board / Cobbler Bundle (40-Pin T-Shaped - Assembled) --- Aketek 50 PCS Jumper Wires Premium 200mm M/F Male-to-Female * 1 Red LED * 1 Red Jumper Cable * 1 Black Jumper Cable * 1 10K Ohm Resistor ( in the strip of 5 ) * Black Electrical Tape * Hot Glue Gun ( Vastar Hot Glue Gun with 30 Pieces Melt Glue Sticks Melting Adhesive Glue Gun Kit for DIY Small Craft and Quick Repairs in Home & Office, 20 Watt ) * Soldering Iron ( Vastar Full Set 60W 110V Soldering Iron Kit - Adjustable Temperature, 5pcs Different Tips, Desoldering Pump, Stand, anti-static Tweezers and Additional Solder Tube for Variously Repaired Usage --- Pics included to show steps --- *** Keep in mind the Longest leg on LED light is the +Positive side *** Using Red Jumper cable for +Positive, solder end to 10K Ohm Resistor *** Solder other end of 10K Ohm Resistor to +Positive end of LED light *** Using Black Jumper cable for Ground, solder that to the other leg of LED light (shorter end) *** Connect other end of Red Jumper cable to spot 4 on GPIO of Raspberry Pi 3 ( Diagram included for GPIO on Raspberry pi included with Kit above ) Pic included but on right side it's the 2nd and 3rd down from top 4-6 *** Connect other end of Black Jumper cable to spot 6 *** If it lights up, then proceed to wrapping each cable in Electrical tape, i then taped both sides together but only after you wrap them independently to avoid contact with each other. *** Using Hot Glue Gun to place and secure the cable and LED to hole. I used a small amount first under the LED light to give it something to rest on, then proceeded to tack it down That's it, and a Big thanks to Old Skool Tools for making this beautiful little case for us to enjoy ;)